Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Opener Repair for Burien Homeowners
A garage door opener that won’t lift is one of the few home failures that stops a household cold – the car stays trapped inside, the kids get walked around to the front door, and the whole routine shifts until it’s fixed. We handle that call across Burien, and we do it as a garage door specialist, not a handyman squeezing in a side job. Our technicians have up to 14 years of experience and know the typical failure modes of the systems most homes here own before they pull into the driveway. Opener repair usually runs $120 – $320, quoted and agreed before any work begins, with a free estimate. Same-day service is often possible. Call (877) 619-3963.
We’re a residential garage door specialist working on three things only: Burien Garage Door Repair, springs, and the openers that drive them. No HVAC, no plumbing, no general repairs. That single-trade focus is why we can recognize a burned-out LiftMaster logic board, a stripped Chamberlain drive gear, or a Genie rail that has slipped its mount within a couple of minutes of looking at it.
What Our Garage Door Opener Repair Service Includes
Every job starts with the same question: is the problem the opener, the door, or the balance between them? We diagnose before we quote, because a door that binds on one side can burn out a perfectly healthy motor and make it look like an opener failure. Here’s what each part of the work covers.
Opener Repair
Opener repair covers the motor unit itself and everything bolted to it – the logic board, drive gear, capacitor, travel limits, and safety sensors. You need it when the door hums but doesn’t move, moves a foot and stops, reverses for no reason, or refuses to respond to the wall button. We test the unit against the door’s actual travel and balance, so we’re repairing the real fault rather than replacing a motor that was never the problem.

Opener Installation
When an opener is beyond economic repair, we replace it – and we size the new unit to the door. A heavy older door needs more lifting force than a modern insulated one, and a machine that’s undersized for the weight will wear out early. Installation is measured and scheduled rather than same-day, and the written price covers the unit, the mounting and the safety testing before we leave.

Smart Opener Upgrade
A smart opener upgrade adds phone control, open-and-close alerts, and scheduled closing to a door you already have. It’s worth considering when you want to let a delivery in without being home or confirm the door is closed after you’ve driven away. We work with the smart-home platforms on current LiftMaster and Chamberlain units and can tell you honestly whether your existing opener supports the feature or needs replacing to get it.

Keypad Entry
A keypad gives you a code-based way in without a remote, which matters for family members, dog walkers, and anyone who has ever locked themselves out of the house through the garage. We install and program keypads and trace the faults when one stops accepting its code – usually a wiring or programming issue rather than a dead keypad. We’ll set the code with you and check the door cycles correctly from the outside before we finish.
Remote Programming
Remote programming is the job of matching a new or replacement remote to your opener, clearing old remotes after a move-in, or fixing a remote that only works close to the door. That last symptom is often an antenna or battery issue rather than a failed remote. We program to the specific brand and generation of your unit, so the remote and the wall control end up behaving the same way.
Battery Backup
A battery backup keeps the opener working during a power cut, so you’re not manually hauling a door up by hand in the dark. We fit and replace backup batteries on units that support them and check that the unit actually switches over when the mains drops. When you need it is simple: any household where the garage is the main way in and losing power means being stuck.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Opener Repair
We work on Raynor operators and the doors that hang from them, including the older mechanical units still running in plenty of Burien garages. Raynor’s drive systems hold up well but their travel limits and safety reverse settings drift with age, and resetting them properly is the difference between a reliable door and a repeat call. We also know LiftMaster and Chamberlain units inside out – the two most common openers in residential use, sharing a lot of internal design, with the same wear points on the drive gear and logic board.
Genie openers have their own quirks: screw-drive and belt-drive models that sound different when they’re failing, and a safety sensor setup that catches people out during a DIY swap. We recognize those sounds and those wiring patterns before we open the housing. Whether you have a Raynor, a LiftMaster, a Chamberlain, a Genie, or a Craftsman, Clopay, Amarr, or Wayne Dalton setup, we can help – and if your opener is paired with a door from one of those makers, we already know both halves of the system.
Signs You Need Garage Door Opener Repair Right Now
Some symptoms are cosmetic. Others mean the opener is about to fail completely, and driving it further can turn a $120 – $320 repair into an installation. These are the ones worth calling about.
- The motor runs but the door doesn’t move. That usually points to a stripped drive gear or a broken chain or belt inside the unit. Continuing to press the button wears the gear further and can burn out the motor, so stop cycling it and get it looked at.
- The door reverses before it reaches the floor. The safety reverse system is doing its job, which means something is telling it there’s an obstruction – misaligned sensors, a travel limit that’s drifted, or a door binding in its track. It needs diagnosing before someone gets hurt or the door jams.
- Loud grinding, banging or scraping. Openers are not supposed to be noisy. A new grinding sound from the housing means internal wear, and a bang from the door itself often means a spring problem that the opener has been masking.
- The door only responds to the wall button. When remotes and keypads go dead but the wall control still works, the fault is usually the receiver board or the antenna, not the remotes. That’s a repair rather than a replacement.
- Repeated reversing or flashing lights with no movement. Flashing lights are the unit reporting a fault code. We read those codes against your brand’s specific meaning instead of guessing at parts.
Our Garage Door Opener Repair Process – Step by Step
- 1
Phone triage. We ask what the door is doing and which brand the opener is, because most symptoms narrow the likely cause before anyone arrives. That means the technician shows up with the right diagnostic direction rather than starting from scratch in your garage.
- 2
Safety and balance check first. Before touching the opener, we test the door’s balance and travel by hand. A door that won’t hold itself halfway open has a spring or cable problem, and no opener repair will fix that – so we identify it now rather than after the invoice.
- 3
Opener diagnosis. We test the motor, drive system, logic board, safety sensors, and every remote and keypad against the unit. We read the fault codes and check the wiring at the wall control. This is where brand familiarity pays off: the failure modes are known, so the tracing is quick.
- 4
Written quote before any work. You get the diagnosis in plain language and a price for the repair, and nothing starts until you agree to it. If the honest answer is that the opener is done and a replacement makes more sense, we’ll say so and quote that instead.
- 5
Repair, test, and walk-through. We complete the repair, then cycle the door several times and test the safety reverse and the sensors with you watching. You leave knowing the door works the same way it did before it broke, and you have the price you agreed to.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Opener Repair Cost in Burien?
A typical garage door opener repair in Burien runs $120 – $320 depending on the fault and the parts involved. The low end covers straightforward work like a sensor realignment, a remote and keypad reprogram, or a travel limit reset. The middle of that range covers a worn drive gear, a capacitor, or a logic board replacement on a common brand. The top of the range is for a more involved repair where the unit has to come down and go back up, or where the openers and the door both need attention.
If the repair turns into a replacement, installation is a different job at $250 – $550, and the written estimate for that covers the unit and the fitting together. Things that move the price: the brand and age of the opener, whether parts are still made for it, whether the fault is mechanical or electronic, and whether the door itself is contributing to the problem. The way to avoid overpaying is to get a diagnosis before agreeing to any parts – a technician who quotes a motor without testing the door’s balance is guessing.
| Job | Typical estimated range |
|---|---|
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Garage door repair (door mechanism) | $150 – $600 |
| Spring repair (one spring) | $180 – $340 |
| Cable repair | $130 – $250 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
Those are typical estimates, and the written estimate sets the final price. The estimate itself is free. If springs come into it, note that a spring price is for one spring, and matched pairs are usually replaced together at about twice that range. Call (877) 619-3963 for an exact quote if you’d rather talk it through first.
Garage Door Opener Repair Near Burien – Our Service Area
We cover Burien and the surrounding area, including White Center, SeaTac, Tukwila, Bryn Mawr-Skyway, Des Moines, and further out to Renton, Kent, Mercer Island, and Vashon. Distance affects when we can get to you, and we’ll give you an honest window when you call rather than an optimistic one. If you’re in a neighboring city, our garage door opener repair page covers White Center specifically. Call (877) 619-3963. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Serving Burien, WA – Our Local Coverage Area
We serve Burien and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Opener Repair in Burien
Garage door opener repair is fixing the motorized unit that raises and lowers your door, plus its controls and safety devices. That covers the motor, drive gear or belt, logic board, travel limits, safety sensors, wall control, remotes, and keypads. We diagnose which of those has failed before quoting, because the fault is often in a different place than the symptom suggests. Call (877) 619-3963 and we’ll help narrow it down on the phone.
Most common opener repairs are finished in a single visit, often within an hour once the fault is identified. A gear, capacitor, sensor, or programming issue is quick work. A logic board replacement or a job where the unit has to come down takes longer, and we’ll tell you at the quote stage which one you’re looking at. The diagnosis always comes before the timeline.
Typical estimated costs are $120 – $320 for opener repair in Burien, depending on the fault and the parts. A sensor realignment or remote reprogram sits at the low end; a drive gear or logic board sits higher. If replacement makes more sense, installation is $250 – $550. The written estimate sets the final price, it’s quoted and agreed before any work starts, and the estimate is free. Call (877) 619-3963 for an exact quote.
Yes. LiftMaster and Chamberlain are among the brands we work on most, along with Raynor, Genie, Craftsman, Clopay, Amarr, and Wayne Dalton. We know where each of those units wears out, which means the diagnosis is usually faster than starting from zero. Whether your opener is one of those or another make, we can help.
Same-day service is often possible for opener problems, and we’ll tell you honestly on the call whether it’s realistic. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. We’re closed on Saturday.
Warranty terms depend on the specific repair and the parts involved, so we put them in writing on the estimate rather than quoting a blanket promise. You’ll know what’s covered before you agree to the work. If anything isn’t clear at that stage, ask, and we’ll spell it out.
Clear the floor under and around the door so the technician can work safely, and make sure the garage is accessible. If you have the opener’s manual or model number, have it handy, though we can identify most units from the housing. Let us know which remotes and keypads are affected and what the door is doing, and don’t keep cycling a door that’s grinding or reversing – it can make the repair bigger.
Schedule Your Garage Door Opener Repair Service in Burien Today
A dead opener doesn’t need a new door or a sales visit. It needs a technician who recognizes your brand and fixes the actual fault, with the price quoted and agreed before anything starts. Call (877) 619-3963 for a free, no-obligation estimate on garage door opener repair in Burien. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Our technicians have up to 14 years of experience, and every job is a garage door job.
Looking at a door problem rather than the opener? Our garage door opener repair page covers that work in SeaTac, and the same team handles garage door repair and garage door spring repair right here in Burien.
Written by the team at Burien Garage Door Repair.