Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Burien Homeowners
A broken garage door spring in Burien usually announces itself with a loud bang from the garage, and the door won’t lift more than a few inches after that. That’s a spring that has failed under load, and it isn’t a job to take on yourself. Springs hold the full weight of the door in tension, and the hardware involved can injure an untrained person badly if it lets go. Our technicians have up to 14 years of experience with high-tension spring work, and spring repair is one of the three jobs we do every day. We handle torsion springs, extension springs, broken spring repair, and safety cable work on the brands most Burien homes actually have. Call (877) 619-3963 and we’ll get your door back to working order.
What Our Garage Door Spring Repair Service Includes
Torsion Spring Replacement
Torsion springs are the coiled springs mounted on the horizontal shaft above the door, and they do most of the lifting on modern sectional doors. When one breaks, the door suddenly feels like it weighs far more than it should, and the opener strains or refuses to move it. We replace torsion springs in matched pairs so the load stays balanced across the shaft, and we set the winding to the door’s actual weight rather than guessing. If your door has been creeping down or your opener has been working harder for a while, a torsion spring replacement is often the fix.

Extension Spring Replacement
Extension springs run along the tracks on either side of the door, stretching as the door closes and pulling it back up. Older Burien homes and lighter single-car doors often have them, and they tend to break without warning after years of stretch and fatigue. We replace them as a pair, check the pulleys and cables they run through, and confirm each spring is rated for the door. If a door came back down hard or stopped lifting evenly on one side, an extension spring failure is a common cause.

Broken Spring Repair
When a spring snaps, the door is effectively stuck, and forcing it up by hand or with the opener can damage the door panels, the tracks, or the opener itself. Broken spring repair means removing the failed spring, matching a replacement to the door’s weight and drum setup, and getting the door balanced again. We treat this as a safety job first: the door stays closed until the spring is replaced and the tension is set correctly. If you heard the bang and the door won’t move, don’t run the opener again – call us.

Spring Adjustment
Sometimes the spring isn’t broken but out of balance, and the door lifts unevenly, drifts down when you let go, or slams the last few inches closed. Adjusting tension is a precise job, and getting it wrong wears the opener and the door hardware faster. We check the door’s balance point, adjust the spring tension to match, and confirm the door stays put at the halfway point. A door that behaves this way usually needs an adjustment, not a full replacement.
Safety Cable Installation
Extension springs should have a safety cable running through the middle of each spring, so if the spring breaks the pieces are contained instead of flying across the garage. Many older doors never got them, and a missing cable is a real hazard we look for on every spring call. We install safety cables during spring replacement when they’re absent or worn. It’s a small addition that makes the whole spring system safer.
Spring Inspection
A spring inspection checks the coils for gaps or rust, the cables for fraying, the drums and bearings for wear, and the door’s balance and travel. It’s worth doing when the door is noisy, slow, or just feels different than it used to. We inspect the whole spring system, tell you plainly what’s worn and what’s fine, and only recommend the repair your door actually needs. Springs don’t last forever, and catching one before it breaks saves you a stuck door on a busy morning.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
We work on Raynor and LiftMaster systems regularly, and those two cover a lot of what’s installed around Burien. Raynor doors have their own drum and spring configurations, and knowing how they’re built means we’re not figuring out the setup from scratch when we arrive. LiftMaster openers paired with a heavy door put specific strain on the springs, and we know where that wear shows up first. Recognizing the system before we start saves time and gets the door back to working order faster.
We also service Chamberlain and Genie equipment, along with Clopay, Amarr, Wayne Dalton, and Craftsman. Chamberlain and Genie openers are common on both older mechanical systems and newer smart-home setups, and the spring work behind them is the same careful job either way. Brand familiarity means we already know the typical failure points on your make, so the diagnosis is quicker and the repair is right the first time. Whether you have Raynor, LiftMaster, Chamberlain, Genie, or any other make, we can help.
Signs You Need Garage Door Spring Repair Right Now
- The door won’t lift or lifts only a few inches. This is the classic sign of a broken spring, and the door is being held by the opener alone. Running the opener again can burn it out or snap a cable, so stop and call.
- You heard a loud bang from the garage. A torsion spring breaking sounds like a gunshot or a heavy weight hitting the floor. That noise almost always means a spring has snapped and the door needs professional repair before it’s used.
- The door feels heavy or slams shut. A door that drops the last few feet or won’t stay up on its own has lost spring tension. It’s a balance problem that will wear the opener and the door hardware if you leave it.
- The door lifts unevenly or looks crooked. One spring doing more work than the other pulls the door to one side. That puts stress on the tracks and rollers, and it usually means a spring has weakened or failed.
- Visible gaps, rust, or stretched coils on the spring. A spring with a visible gap in its coil, heavy rust, or an overstretched extension spring is close to failing. Having it replaced on your schedule beats a stuck door on a morning you’re trying to leave.
Our Garage Door Spring Repair Process – Step by Step
- 1
We listen and confirm the symptom. Before we touch anything, we ask what the door did, when it happened, and whether the opener was used after. That tells us whether we’re looking at a torsion or extension setup and whether the opener may have taken damage too.
- 2
We inspect the full spring system. We check the springs, cables, drums, bearings, and the door’s balance, along with the opener if it was strained. A worn cable or a bad bearing can make a spring problem worse, so we look at the whole picture rather than just the broken part.
- 3
We give you a written estimate before any work starts. The price is quoted and agreed with you up front, and the written estimate sets the final price. You’ll know what the repair involves and what it costs before we begin.
- 4
We replace the spring with the right hardware. Springs are matched to the door’s weight, and torsion springs are replaced as a pair so the door stays balanced. We use the proper winding tools and set the tension to spec, which is the part of the job that makes DIY dangerous.
- 5
We test the door and confirm it’s balanced. We cycle the door, check that it stays put at the halfway point, and confirm the opener and safety reverse are working. You get a door that’s back to working order, tested before we leave.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Burien?
Garage door spring repair in Burien typically runs $180 – $340 for one spring. A matched pair is usually replaced together, since springs wear at the same rate, so a pair costs about twice that range. A broken spring, a torsion or extension replacement, a spring adjustment, and safety cable work all fall within that range depending on what your door needs.
Several things move the price within that range. Torsion springs cost a bit more than extension springs because of the winding and the paired replacement. The door’s size and weight matter, since a heavy double-car door uses different springs than a single. Rusted or worn cables, drums, and bearings add to the job if they need attention at the same time. A spring that’s broken but surrounded by healthy hardware is the simplest repair.
To avoid overpaying, get the estimate in writing before work starts and make sure it covers the spring, the labor, and any cable or hardware that’s part of the fix. A free estimate means we inspect the door, explain what’s worn, and quote the job so you can decide. The price is quoted and agreed before any work starts, and the written estimate sets the final price, so there’s no surprise on the invoice. Call (877) 619-3963 for a free estimate.
| Service | Typical Estimated Range |
|---|---|
| Spring Repair (one spring) | $180 – $340 |
| Matched pair of springs | About twice the single range |
| Cable Repair | $130 – $250 |
| Opener Repair | $120 – $320 |
| Track Realignment | $120 – $240 |
Garage Door Spring Repair Near Burien – Our Service Area
We handle garage door spring repair across Burien and the surrounding area, including White Center, SeaTac, Tukwila, Des Moines, and Bryn Mawr-Skyway, with fast dispatch from 7am to 7pm, Sunday through Friday. If you’re nearby and your door is stuck, call and we’ll book the soonest opening. We also cover garage door spring repair in neighboring communities. Wherever you are in the area, call (877) 619-3963.
Serving Burien, WA – Our Local Coverage Area
We serve Burien and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Burien
Garage door spring repair is the replacement or adjustment of the springs that counterbalance the weight of the door so it can be lifted by hand and by the opener. Torsion springs sit on a shaft above the door, extension springs run along the sides, and when either fails the door won’t lift safely. Repair means removing the failed spring, fitting a correctly rated replacement, and balancing the door. It’s a job for a trained technician because the springs are under high tension. Call (877) 619-3963 if your door won’t lift.
Most spring repairs take a couple of hours once we’re on site, depending on whether it’s a torsion or extension setup and whether cables or hardware need attention too. A straightforward single-spring replacement is quicker than a full paired job with new cables. We give you a clear picture when we quote the work so you know what to expect. Call (877) 619-3963 to book a free estimate.
Spring repair in Burien typically costs $180 – $340 for one spring, and a matched pair usually runs about twice that because the springs are replaced together. The final price depends on the spring type, the door’s size and weight, and whether cables or hardware need replacing at the same time. The written estimate sets the final price, and the price is agreed before any work starts. Call (877) 619-3963 for an exact quote – estimates are free.
Yes, we service LiftMaster and Genie, along with Chamberlain, Raynor, Clopay, Amarr, Wayne Dalton, and Craftsman. Knowing those brands means we already understand the typical failure points on your system, so the diagnosis is quicker. Whether it’s a legacy mechanical opener or a modern smart-home platform, we handle the spring work behind it. Call (877) 619-3963 and tell us what you have.
Often yes. Spring repair is one of our core services, and we offer same-day service with fast dispatch from 7am to 7pm, Sunday through Friday. We answer 24/7, so if your door fails early or late, call and we’ll book the soonest opening. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Call (877) 619-3963.
We stand behind our spring work, and we’ll walk you through what’s covered on your specific repair when we quote it. Springs are replaced with correctly rated hardware so the fix holds, and we test the door before we leave. If something isn’t right after the work, call us and we’ll make it right. Call (877) 619-3963 with any questions.
Clear the area under and around the door so the technician has room to work, and don’t run the opener once a spring has broken – leave the door closed. Move cars out of the garage if you can, and have a note of what the door did and when it started. That’s all the preparation you need. Call (877) 619-3963 to book a free estimate.
Springs are one of the most dangerous parts of a garage door to handle, and we treat them that way. Our job is to get your door back to working order safely. For related fixes, we also handle garage door repair and Burien Garage Door Repair.
Schedule Your Garage Door Spring Repair Service in Burien Today
A stuck door doesn’t wait, and neither should you. Call (877) 619-3963 and we’ll book a free, no-obligation estimate for your spring repair. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. You’ll get a written price before any work starts, and a door that’s back to working order. We also cover garage door spring repair nearby. Call (877) 619-3963 today.
Written by the team at Burien Garage Door Repair.